I have a 1.2m dish (Andrew) . I'd like to use it for my Starband link, but lack the feed assy for the Starband tx/rx. It was a rx only dish in it's previous life. I'd even buy new if I could find the right feed. Any advice gratefully accepted.
Thanks, Eric
1.2m feed assy wanted
Forum rules
This section is for non-commercial use ONLY. Dealers can do a one time post if they are trying to sell used equipment for a customer.
As usual no foul language or personal attacks.
This section is for non-commercial use ONLY. Dealers can do a one time post if they are trying to sell used equipment for a customer.
As usual no foul language or personal attacks.
2 posts
• Page 1 of 1
1.2m feed assy wanted
by oldford » Sun Apr 18, 2010 12:59 pm
Starband in Eastern Maine
www.satnetmaine.com
www.satnetmaine.com
- oldford
- Posts: 8
- Joined: Sun Jul 27, 2008 11:34 am
Re: 1.2m feed assy wanted
by chickenman » Thu May 13, 2010 6:48 pm
Eric,
Try this place http://www.satellitedish.com/page-31.htm
scroll down until you find the junction block. You need the metal one for 1.2 mtr dish.
Good luck, Dick
Try this place http://www.satellitedish.com/page-31.htm
scroll down until you find the junction block. You need the metal one for 1.2 mtr dish.
Good luck, Dick
Dick Hammond
Fortymile Country
Chicken, Alaska
Fortymile Country
Chicken, Alaska
- chickenman
- Posts: 112
- Joined: Sat Jul 19, 2008 1:14 am
- Location: Chicken, Alaska
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest